PTS Program Listing

CH1
RF-100
CH2
MW00000001
SB10000
RJ9000

ES50
CH1/VC+

ES51
CH1/ST

ES100
CH2/ML1/XM78

# Channel 1 (conveyor) parameters
# Reference offset for master
# Channel 2 (feeder) parameters
# Use the software clutch
# Label pitch in encoder counts
# Reference correction during space
# in labels
# Machine start sequence
# Start Conveyor
#
# Machine stop sequence
# Stop Conveyor
#
# Feed roller start sequence
# Run map 78 (a non-linear profile
# to match conveyor speed over one
# label length)

ES101
CH2/ST

CH1/DR1+

CH2/DR2-

CH1/PO4+/-500/2000

CH2/DI4+/XS100

CH2/DI4-/XS101

# Feed roller stop sequence
#
#
# Input definitions
# Product photocell is active high
# when it sees a product
# Label photocell is active low
# when it sees a label
# Position trigger output to provide
# feed roller start signal
# Input 4 is wired to output 4 &
# starts feed roller from CH1 signal
# Stops feed roller upon signal from CH1